BaiCells EG7035L-M1 Atom OD04 Outdoor LTE Cat 4 CPE, 2.5 GHz, 11 dBi

The BaiCells EG7035L-M1 Atom OD04 is an outdoor LTE customer-premises equipment device designed to provide broadband connectivity over compatible LTE TDD networks. It combines cellular connectivity, an integrated directional antenna, wired Ethernet, and network-management capabilities in an outdoor enclosure.

LTE connectivity

The EG7035L-M1 supports 3GPP Release 9 LTE Cat 4 and is the 2.5 GHz version designed for LTE TDD Bands 40 and 41. Its integrated directional 1T2R antenna has a manufacturer-specified gain of 11 dBi at 2.x GHz.

The manufacturer lists peak LTE rates of up to 100 Mbps downstream and 10 Mbps upstream at 20 MHz bandwidth. Actual performance depends on network coverage, signal quality, network load, and service configuration.

Ethernet and PoE power

The newer manufacturer datasheet lists one RJ45 Ethernet interface supporting 10/100/1000 Mbps and PoE. The specified power supply provides 24 V DC at 0.5 A. Confirm the correct PoE injector, voltage, polarity, and pinout before connecting the device.

Outdoor installation

The IP65-rated enclosure is designed to protect against dust ingress and water jets under the applicable test conditions. The device supports pole or wall mounting. Appropriate grounding, weatherproof cable installation, and secure mounting are important for outdoor use.

Management and configuration

The CPE supports local and remote web management, TR-069, and SNMP. Its documented network features include NAT or bridge operation, IPv4/IPv6, SIM PIN management, SIM locking, cell locking, firewall controls, port forwarding, VPN functions, and diagnostic tools, subject to firmware support.

Wi-Fi alignment

The datasheet documents 2.4 GHz Wi-Fi functionality for alignment during installation. This should not be advertised as general-purpose Wi-Fi access for customer phones, laptops, or other wireless clients without additional confirmation for the exact hardware revision.

1. Key Features

• Brand: BaiCells

• Model / MPN: EG7035L-M1

• Product family: Atom OD04 outdoor low-gain CPE

• LTE standard: 3GPP Release 9, Cat 4

• Frequency variant: 2.5 GHz

• LTE bands: Bands 40/41

• Integrated antenna: Directional, 1T2R

• Antenna gain: 11 dBi at 2.x GHz

• Ethernet: One RJ45 10/100/1000 Mbps interface, according to the newer manufacturer datasheet

• Power: 24 V DC passive PoE, 0.5 A

• Ingress protection: IP65

• Mounting: Pole or wall

• Management: Local/remote web management, TR-069, SNMP

• Device dimensions: 241 × 154 × 50 mm (9.5 × 6 × 2 inches)

• Device weight: Approximately 900 g (2 lb)

2. Technical Specifications

3. Applications / Use Cases

• Outdoor fixed wireless broadband access

• LTE connectivity for rural and remote locations

• Outdoor customer-premises connectivity on compatible LTE networks

• Pole-mounted or wall-mounted LTE installations

• Broadband connectivity for small business and distributed sites

• LTE deployments using compatible Bands 40 or 41

• Wired network connectivity for compatible Ethernet equipment

4. Compatibility

Before ordering, verify the following:

• LTE network: The operator must support a compatible LTE TDD frequency band.

• Frequency variant: This is the 2.5 GHz Band 40/41 version. Do not assume compatibility with the 3.5 GHz Bands 42/43/48 version.

• SIM: Uses a 2FF USIM supporting 1.8 V/3 V. The SIM must be activated and provisioned for a compatible LTE service.

• Ethernet: The newer datasheet specifies an RJ45 interface supporting 10/100/1000 Mbps. Confirm the hardware revision because an older manual describes a 10/100 Mbps interface.

• Power: Requires compatible 24 V DC PoE equipment rated for the specified current. Confirm voltage, polarity, and pinout.

• Installation: Suitable for pole or wall mounting with compatible hardware.

• Regional compliance: Verify the unit's regulatory label and supported frequency range for the destination market.

Carrier compatibility and service availability are not guaranteed solely by the model number.

5. What’s Included

• 1 × BaiCells EG7035L-M1 Outdoor LTE CPE with Simple Mounting Bracket

• 1 × Power Cord

• 1 × PoE Adapter

• 1 × User Manual

6. Frequently Asked Questions

Q1. What is the BaiCells EG7035L-M1 used for?

It is an outdoor LTE Cat 4 CPE designed to provide broadband connectivity over compatible LTE TDD networks, particularly for fixed wireless access.

Q2. Which LTE bands does this model support?

The EG7035L-M1 is the 2.5 GHz model for LTE TDD Bands 40 and 41.

Q3. What is the antenna gain?

The device has an integrated directional LTE antenna with a manufacturer-specified gain of 11 dBi at 2.x GHz.

Q4. Does it support Gigabit Ethernet?

The newer manufacturer datasheet specifies one RJ45 interface supporting 10/100/1000 Mbps. An older user manual lists 10/100 Mbps, so verify the hardware revision before advertising Gigabit Ethernet for a specific unit.

Q5. How is the device powered?

The datasheet specifies PoE at 24 V DC and 0.5 A. Use compatible power equipment and verify the connector and pinout before installation.

Q6. Can it be installed outdoors?

Yes. The device has an IP65-rated enclosure and supports pole or wall mounting. Correct grounding, cable sealing, and installation are still necessary.

Q7. Does it provide Wi-Fi for phones and laptops?

The manufacturer documents 2.4 GHz Wi-Fi for installation alignment. General-purpose Wi-Fi client access is not confirmed by the reviewed specifications.

Q8. Will it work with any LTE carrier?

No. The operator must support a compatible LTE band, and the device must be accepted and provisioned for the network. Confirm compatibility before purchasing.

7. Why Buy from Multilink Solutions?

Multilink Solutions Inc. helps businesses source networking equipment for broadband and infrastructure projects.

• Product identification using manufacturer model numbers

• Technical specification review to support informed purchasing

• Assistance with product selection and deployment requirements

• Support for business networking and connectivity procurement